www.ford-econoline.com
http://www.ford-econoline.com/forum/

Brakes? What brakes?
http://www.ford-econoline.com/forum/viewtopic.php?f=1&t=101
Page 1 of 1

Author:  Swifty [ Tue Jan 16, 2007 9:10 pm ]
Post subject:  Brakes? What brakes?

:shock: Another dumb question, I contacted Mac's and asked about brake parts, they apparently do not stock a master cylinder. Any other sources for this? Is there something else to adapt? On Falcons you can use one from a Mercury Tracer (cheap) or an early Mustang (not cheap) I am anticipating having to replace most of the brake parts as the truck has been sitting for awhile and I am rather fanatical re. brakes/tires.

Author:  66 surfin [ Wed Jan 17, 2007 3:21 pm ]
Post subject: 

Do you have the original cyl.? Is it a dual resivor ? If so have your orig. one rebuilt , do it your self or send it out to an independent re-builder. Check in Hemmings for your area.

Author:  67supervan [ Tue Feb 27, 2007 12:18 pm ]
Post subject:  67supervan

go to denniscarpenter.com they sell rebuild kits i had to do that and it works good and olny cost about $55

Author:  Terry Turner [ Wed Jan 13, 2010 4:38 pm ]
Post subject:  master cyl

get White Post Restorations to rebuild it for you. Lifetime warranty. Doesn't matter if its '61-'66 single or '67 dual. Around $125-$175 parts and labor. White Post, VA.

Author:  Terry Turner [ Wed Jan 13, 2010 4:38 pm ]
Post subject:  master cyl

get White Post Restorations to rebuild it for you. Lifetime warranty. Doesn't matter if its '61-'66 single or '67 dual. Around $125-$175 parts and labor. White Post, VA.

Author:  Terry Turner [ Thu Jan 14, 2010 11:17 am ]
Post subject:  brakes PS

P.S.--Dont buy from Dennis Carpenters. His money goes to China and what he does offer and make for early E-100's is not good quality and/or poor fit.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/