www.ford-econoline.com
http://www.ford-econoline.com/forum/

VIN ID
http://www.ford-econoline.com/forum/viewtopic.php?f=1&t=322
Page 1 of 1

Author:  Smitty [ Sun Dec 23, 2012 7:24 am ]
Post subject:  VIN ID

I bought a Econoline Pickup and nedd the vin decoded.
The vin # is E10FH835969
Thanks :?:

Author:  econoaddict [ Sun Dec 23, 2012 7:33 am ]
Post subject:  Re: VIN ID

E10 = E100 Pickup, Body Code 87A = Std pickup or 87B = Dlx. pickup
F = 170 ci engine
H = Lorain Assembly Plant
835969 = March of 1966 Build Date

All info id from the 66 manual, hope this helps

Author:  Smitty [ Sun Dec 23, 2012 10:57 am ]
Post subject:  Re: VIN ID

ecenoaddict, thank you for the vin info. I picked up two pickups for a thousand bucks. There is enough to make one good one. I have two Corvair coups and wanted a rampside but I couldn't pass these up . I guess theis makes me a Ford/ Chevy guy. I will post some pics later.

Author:  econoaddict [ Sun Dec 23, 2012 11:08 am ]
Post subject:  Re: VIN ID

Anytime.
Nothing wrong with having a good selection out in the driveway. 8)

Author:  Barnabas [ Mon Dec 24, 2012 10:19 am ]
Post subject:  Re: VIN ID

It is a 1966 model assembled in March 1966.

Author:  econoaddict [ Mon Dec 24, 2012 11:17 am ]
Post subject:  Re: VIN ID

Barnabas wrote:
It is a 1966 model assembled in March 1966.


You are absolutely correct.
I corrected my post, not sure why I put 65, I had the 66 manual in my hand. :roll:

Author:  Smitty [ Mon Dec 24, 2012 2:13 pm ]
Post subject:  Re: VIN ID

Thanks again.

Author:  Smitty [ Mon Dec 24, 2012 2:28 pm ]
Post subject:  Re: VIN ID

I have been doing quite a bit of work to the pickup. Here is a list.

!. removed gas tank and fixed many holes that were on the top - reinstalled
2. removed rear end and springs and painted same-reinstalled
3. removed front axle and springs.
4. in process of installing new king pins
5. replaced master cyl
6. 4 new wheel clys
7. new brake lines and hoses
8. new clutch pedal pivot bushing
9. removed dog house , sides , front and back so that I can repair rusty floor
10. painted frame rails ( found out that they have a galvinised coating ) ( lots of undercoating on the bottom of truck )
11. cleaned and painted cover that is below foot area

Will be taking engine out to detail

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/