www.ford-econoline.com
http://www.ford-econoline.com/forum/

disc brake/master conversion
http://www.ford-econoline.com/forum/viewtopic.php?f=1&t=400
Page 1 of 1

Author:  dick w. [ Fri Nov 29, 2013 8:26 am ]
Post subject:  disc brake/master conversion

I'm passing this link along. It's for disc brake and master cylinder conversion parts and kits for 61-67 econolines. They have some sheet metal and a few other things as well. Great resource! The website is called D&D Econo Disc Brakes @ http://www.dddiscbrakes.com/index.html
check it out.
Secondly, can anyone tell me is there any rear axles other than an econoline that will at least come close to fitting a '62 pickup? I'm not afraid of a little fabrication on the axle housing. any help would be appreciated.
thanks,Dick w.

Author:  Barnabas [ Mon Dec 09, 2013 7:15 pm ]
Post subject:  Re: disc brake/master conversion

The Econos had a unique width on the 9" axle. Some have tried axles that are slightly wider or narrower and used offset wheels.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/