www.ford-econoline.com
http://www.ford-econoline.com/forum/

Aussie xflow Econo
http://www.ford-econoline.com/forum/viewtopic.php?f=1&t=85
Page 1 of 1

Author:  econoline-64 [ Sun Nov 19, 2006 9:09 pm ]
Post subject:  Aussie xflow Econo

Some of you may remember a few years back I had a dream to put an Aussie crossflow 250 in my 64 Travelwagon. Well my dream is about to become a reality. I have finally secured all the pieces to rebuild the crossflow engine and put a C4 trans behind it so that I can instal them in the Econo.

I will try and send some pics through to document the project.
I am not that good with computers so I may have to snail mail a picture disc to someone to post them for me. Anyone want to volunteer for this job.

I won't be posting this on the other two Yahoo Econo sites. If any one asks to see the pics I will refer them to this site. Hopefully this will bring up the activity level on this site. In my opinion, this used to be the Premier Econo site before it got crashed a few years back.

David in Dayton, TX

Author:  Vanish [ Mon Nov 20, 2006 8:51 pm ]
Post subject: 

:wink:

Hey David, Shoot me the pics I will post them here for ya !!!!!!!!!!!!!




Vanish........................

Author:  econoline-64 [ Tue Nov 21, 2006 12:21 pm ]
Post subject: 

Vanish,
I think I can get the pictures to go to the picture page. If I can't make that happen I will snail mail you a disc. Please provide me with a snail mail address to which I can send a disc. I will be starting to take the 200 C-4 combo out of the van the week after Thanksgiving and will be starting to take the before change pictures at that time.
David

Author:  Vanish [ Wed Nov 22, 2006 9:00 pm ]
Post subject:  David !!!!!!!!!!!!!!

:wink:
David just let me know if I can help !!!!!!!!!!!!

and your Right, this was and is a great site and it will come back !!!!!!!!


Vanish......................................

Author:  econoaddict [ Sat Nov 25, 2006 8:03 pm ]
Post subject: 

If you like you can send the disc to me and I can put a page together for the project.

Just say the word.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/