www.ford-econoline.com
http://www.ford-econoline.com/forum/

1966 Econoline truck engine removal
http://www.ford-econoline.com/forum/viewtopic.php?f=2&t=235
Page 1 of 1

Author:  Bob Miller [ Sat Nov 28, 2009 6:33 pm ]
Post subject:  1966 Econoline truck engine removal

I have people tell me that it's best to remove the engine from above, others say drop it out below. Which is best?

Author:  Bill W [ Sun Nov 29, 2009 8:42 pm ]
Post subject: 

I have done this... best to drop the engine to the ground, trying to get the motor through the door was a PAIN! if you have a van with side doors you can go through them easy with a engine hoist.

Good luck!

Author:  kgdb [ Wed Dec 02, 2009 9:47 pm ]
Post subject:  Re: 1966 Econoline truck engine removal

Bob Miller wrote:
I have people tell me that it's best to remove the engine from above, others say drop it out below. Which is best?


I found through the passenger door to be very easy. When I was doing the 302 conversion I had the motor with trans in and out about 5 times while setting up the mounts. Very easy to do through the door opening.

kgdb

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/