www.ford-econoline.com
http://www.ford-econoline.com/forum/

Original windshield seal
http://www.ford-econoline.com/forum/viewtopic.php?f=4&t=326
Page 1 of 1

Author:  Smitty [ Tue Jan 08, 2013 8:32 pm ]
Post subject:  Original windshield seal

My original windshield seal is like a rock. It is hard , real hard. A knife will not cut it. Is there an easy way to remove the seal portion that is on the outside without cracking the glass? Any ideas ?

Author:  econoaddict [ Tue Jan 08, 2013 9:49 pm ]
Post subject:  Re: Original windshield seal

No expert here but......

Maybe try some light heat (hair dryer/heat gun on low) to soften it up a bit?
or try some thin piano wire, work it through to the inside and using a helper work it along and push/pull with a sawing type motion? I've watched glass guys do this.

Author:  Smitty [ Tue Jan 29, 2013 6:55 pm ]
Post subject:  Re: Original windshield seal

I finally got my seal cut with one of those knifes that you break the blade off and the next on is ready. Took some time.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/